The SRS Washout System is patent protected and durable, it uses parts that are readily available. It is simple and easy to use and no truck modifications are required.

The system is the only patented air-driven solution
    on the market today.

Admixtures can be poured into the system for tank
    delivery at the job site.

Approximately 25 gallons of slurry can be captured
    before being returned to the mixer drum.

No truck modification are required to install the tank;
    the truck uses its own air and water systems.

Any maintenance can be done without removing
    the system from the truck.

Concern for environmental fines are eliminated because
    there is virtually no chance for leaks or spills that
    frequently occur with other systems.

As the best available technology on the market, it
    improves the overall operation of any job site because
    the slurry never leaves the truck.

The SRS Washout System is the best available technology
    for concrete washout

SRS Washout System's competitive edge is in it's "three-in-one" product design features. The system can be used as a reclamation unit for slurry, an extra holding tank for water as well as a chemical storage tank for admixtures. There are no moving parts that could plug or malfunction while in use. Patented peripherals also give the SRS Washout System added operational value to the ready-mix driver.

The SRS Washout System is easily installed in typically 2-4 hours (per truck).

The SRS Washout System can be used to hold admixtures that can be added to the mix on location.

The SRS Washout System is the only proven recycling solution because it never allows slurry to leave the truck.

The SRS Washout System succeeds in preventing onsite construction waste with no other reclamation
or containment equipment.

The SRS Washout System prevents pollution at point source and complies with zero waste mandates
using the best available technology.

The "Win-Win" Analysis
The use of the Washout System attached to the ready mix truck has bottom-line profit potential for the ready-mix companies as well as compliance concerns for the regulatory agencies. The introduction of our new technology creates perfect win-win scenario due to the following information. At each Construction site, the Developer is responsible for the containment of these concrete slurry washouts which falls under the SWPPP program. Comparatively, the cost for the Metal Container "Roll off System" (Bin) is approximately 48% higher to maintain than the SRS Washout System.

Services & Warranty Policy
All Washout Tank Systems will carry a full one-year manufacturers warranty on parts. All systems will carry a 30 day warranty on installation service performed by SRS. Any defective parts will be replaced for the client during the one year period at no additional cost to the client, provided all requirements and use of the Washout System has been met. Any installation service required where SRS did not originally install the unit will be charged a service fee.